 HomeNews

2026-01-20

How Do Cranked Hinges Work

Cranked hinges are hinges with an offset (a “crank”) in the hinge leaf or arm. That offset shifts the pivot point so the door or panel sits in a different plane relative to the frame. In practice, the crank controls overlay, clearance, and how far the door opens.
2026-01-19

How Big Should Gate Hinges Be

Gate hinge size depends on gate weight, gate width, material, and hinge type. There’s no single “correct” size—hinges must be large enough to carry the load, prevent sagging, and withstand outdoor use.
2026-01-16

Can You Tighten Door Hinges

Yes—you can and should tighten door hinges.Loose hinges are one of the most common causes of sagging doors, rubbing, and latch misalignment. Tightening them is often the first and easiest fix.
2026-01-15

Can You Shim Door Hinges

Yes—you can shim door hinges, and it’s a common, effective way to correct door alignment issues without rehanging the door. Shimming adjusts how far the hinge leaf sits from the door or frame, which changes the door’s position.
2026-01-14

Can You Replace Door Hinges Without Removing The Door

Yes—often you can replace door hinges without fully removing the door, as long as you support the door properly and replace one hinge at a time. This is a common technique used to avoid rehanging and realignment.
2026-01-13

Can You Cut Piano Hinge

Yes, a piano hinge can be cut to size—and it’s commonly done during installation. The key is using the right tools and technique so the hinge remains straight, functional, and safe.
2026-01-12

Can You Adjust Cabinet Hinges

Yes—most modern cabinet hinges are adjustable.In fact, adjustability is a standard feature on contemporary cabinets and is used to fine-tune door alignment after installation or as cabinets settle over time.The amount and type of adjustment depend on the hinge style.
2026-01-09

How Are T Hinges Measured

T hinges are measured primarily by the length of the strap (the top of the “T”), along with several secondary dimensions that affect strength, fit, and alignment. Correct measurement ensures the hinge can support the door or gate without sagging.
2026-01-08

How Are Gate Hinges Measured

Below is a clear, practical guide used by installers and manufacturers.
2026-01-07

Does A Bifold Hinge Join Perpendicular Or at The Corners

A bifold hinge joins two panels at their edges (corners), allowing them to fold together like a book.It does not join panels at a perpendicular, 90-degree intersection like a corner hinge or butt hinge used on frames.
2026-01-06

Do You Need Special Hinges for Fire Doors

Yes. Fire doors require fire-rated hinges.Standard door hinges are not acceptable for fire door assemblies because they may fail under high heat, compromising the door’s ability to contain fire and smoke.
2026-01-05

What Is A Lever Lever Door Handle

A lever lever door handle is a door handle set that uses lever handles on both sides of the door—one lever on the exterior side and one lever on the interior side—connected through a latch or lock mechanism.

Request A Quote

* Your Name

This value is required!

* E-mail

This value is required!

* Mobile / WhatsApp

This value is required!

Your Company

Message

This value is required! Minimum is 20 characters

Home